Liquid desiccant for use in vehicle car washes with air blowers

Facilitates rapid breakup of large areas of water film

• Water is largely removed from the vehicle surface before the blower is used
• Excellent drying

Creates an additional protective film

• Vehicle surface develops a smart shine
• Rainwater beads off

Free of phosphate, AOX and silicone

pH value in the concentrate: approx. 4

Free of mineral oil and hydrocarbons

Does not compromise the effectiveness of light fluid separators.

Easily biodegradable in accordance with OECD.

OECD = Organisation for Economic Cooperation and Development

Notice

Store in a frost-free place! Avoid overdosing! Only use on cleaned and rinsed surfaces.

The usage instructions are recommendations based on the tests we have conducted and based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

For use in car wash systems and self-service car wash systems.

Instructions

When dispensing using the dispensing pump, draw in undiluted. When dispensing using an injector, stir 1 part high gloss desiccant to 9 parts water.

Application concentration: approx. 0.2%

Consumption per vehicle: approx. 8u201310u00a0ml

Suitable glove:

Nitrile chemical protective glove

Permeation level: 3

Cotton velour lining

Nitrile chemical protective glove, heavy-duty

Permeation level: 4

Long, heavy-duty design

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.