Lithium-soap graphite grease resistant to high pressures with EP additives.

• EP additives for high pressure resistance
• Graphite for excellent dry-running properties
• Good sealing effect and corrosion protection
• Excellent resistance to dust, dirt and water
• Comes in practical "pull-off" cartridge

Notice

Greases are supplied in plastic cartridges. The plastic cartridges improve storage (they prevent the grease from oozing out at high temperature). Store cartridges upright in a cool, dry place! The operating instructions of the vehicle, machinery and assembly manufacturers must be observed!

The usage instructions are recommendations based on the tests we have conducted and based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and carry out further development.

Suitable for medium and heavily loaded roller bearings, journal bearings, ball bearings, shafts, rotary joints, live rings, sliding guides, sliding rails, spline shafts, joint bars, hinges and hydraulic equipment. Also suitable for lubricating journal and roller bearings with a relatively high slide friction proportion, such as those found in all types of vehicles, construction machinery, agricultural machinery and industrial machinery.

Instructions

Remove the head piece using the lever, then tension the slide pin and spring and insert the cartridge. Screw on the header, disengage the sliding pin; the hand-lever grease gun is then ready to use.

Suitable glove:

Nitrile chemical protective glove

Permeation level: 6

Cotton velour lining

Nitrile chemical protective glove, heavy-duty

Permeation level: 6

Long, heavy-duty design

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.