For professional application of 1-component gun foams

Low tare weight

Easy and effortless handling

Ergonomic handle shape

Fits securely in your hand

Optimised sealing system

A seal combination means it is no longer necessary to readjust the needle seal

Foam dispensing can be controlled

Foam dispensing quantity can be adjusted variably - enabling a clean spraying pattern

Easy to clean

Foam accumulations are reduced thanks to the nano coating on the needle and cone

Notice

A polyurethane foam can should always be screwed onto the PURLOGIC® guns. The gun should be cleaned with PURLOGIC® Clean at regular intervals. Please refer to the instructions for use

Can be used for all Würth 1-component gun foams.

When used with other polyurethane foam cans, the function should be tested beforehand

The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

The gun is used to apply 1-component polyurethane foam. All commercially available gun foams in aerosol spray cans with standard screw-on adapter are suitable. Being able to precisely adjust the PU foam quantity means that the gun is suitable for controlled dispensing and customised filling of joints, thereby enabling precise and secure installation.

Instructions

Check that the gun is suitable and works before use. Shake the foam can vigorously and remove the cap. Screw the gun onto the upright can. To ensure that no foam escapes from the side of the adapter, do not hesitate when working (if necessary, remove with PU foam clean, art. no. 0892 160). Lightly press the trigger to fill the gun with foam. The gun is now ready to use.

Position the required flow of material with dispensing screw at the back of the gun: Turning in a clockwise direction reduces the foam output; turning in anti-clockwise direction increases the foam output. Check which setting gives you optimum results.

Art.-no.: 0891152212

Flat nozzle

JNTTP-FMGUN-PE-L100MM

For PURLOGICu00ae COMBIpress and Xpress foam gun.

Additional accessory:

Art.-no.: 0891152211

Extension tube

JNTTP-FMGUN-EXTENSION-XPRESS-COMBIPRESS

For PURLOGICu00ae COMBIpress and Xpress foam gun.