5915020175 | Wurth.am

0x - +	Please log in to see the price	Add to cart

Specification

For W-VD/S, W-VD-IG/S, W-VD-IG/A4, W-VD/A4, W-VD/HCR compound anchors

High load-bearing capacities, low axial and edge clearance
Cured injection mortar provides best possible seal for drill hole
Attachment with low expansion pressure allows minimal edge and axial clearance
Anchorage via bond between mortar, anchor rod and anchoring base. Galvanised steel anchor rod in sizes M8, M10, M12, M16, M20 and M24

Notice

Clean the drill hole: 1x blow out, 1x brush out, 1x blow out, 1x brush out

Insert anchor rod using hammer drill or impact drill in rotation + impact mode.

Application

Can be used for medium to heavy loads

The anchor has European Technical Approval for use in reinforced or non-reinforced standard concrete with a strength class of min. C20/25 and max. C50/60 in accordance with EN 206:2000-12

Anchorage with European Technical Approval in non-cracked concrete (compression zone)

The anchor may be used for anchorages with predominantly static loads (e.g. tare weight, fittings, stored materials) or quasi-static loads

Installation in dry or wet concrete

The temperature in the area surrounding the mortar must not exceed +50u00b0C and short term +80u00b0C

For use in concrete

W-VD/S (galvanised steel) can be used in dry indoor areas

Suitable for fastening metal structures, metal profiles, brackets, base plates, supports, wooden structures, beams etc.

Technical information

Thread diameter	20 mm
Effective anchoring depth (h ef)	170 mm
Nominal drill-bit diameter (d 0)	25 mm
Drill hole depth (h 0)	170 mm

Suitable glove:

Natural latex and neoprene chemical protective glove

Permeation level: 1

Cotton flocking on the inside

Butyl chemical protective glove

Permeation level: 3

Gas-tight and resistant to exhaust gases produced by combustion processes

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Measured breakthrough time	Permeation level
< 10 min	0
u2265 10 min	1
u2265 30 min	2
u2265 60 min	3
u2265 120 min	4
u2265 240 min	5
u2265 480 min	6

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.

Product information