Flux paste in accordance with DIN EN 1045, type FH10

• Flux for brazing copper, brass and red bronze gunmetal
• DIN 29454
• White paste

Notice

The residues of the fluxing agent are corrosive and must therefore be removed.

Fluxing agent for hard soldering copper, brass and red bronze gunmetal alloys except for light metals with an operating temperature range from 500°C to 800°C

Instructions

Mix paste well before using. Apply fluxing agent to the cleaned work piece by brushing or immersion. Flux agent should also be applied to the area around the soldering point.

Nitrile chemical protective glove

Permeation level: 5

Cotton velour lining

Nitrile chemical protective glove, heavy-duty

Permeation level: 6

Long, heavy-duty design

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.