Permanently plastic engine and housing sealing compounds with high degree of temperature resistance

• Excellent sealing ability thanks to permanently plastic (non-hardening) properties
• Resistance to vibration guaranteed even after years of exposure
• No pulling of threads during application
• Does not run on vertical or downward-sloping surfaces
• Temperature-resistant from -50u00b0C to +270u00b0C, briefly up to +300u00b0C
• Poor heat conductivity
• Does not bond to metals or other materials chemically, prevents atmospheric corrosion
• Resistant to water, air, petrol, kerosene, numerous oils, synthetic lubricants, water/glycol and methanol compounds, anti-freeze, fluorocarbon cooling agents
• Silicone-free
• Non-toxic
• Cannot be used as a replacement for solid seal, but can be used with them

Notice

Not suitable for sealing oil pans.

Material combinations:

1. Metal - metal

2. Metal - plastic

3. Plastic - plastic

The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Suitable glove:

Nitrile chemical protective glove

Permeation level: 1

Cotton velour lining

Nitrile chemical protective glove, heavy-duty

Permeation level: 1

Long, heavy-duty design

Natural latex and neoprene chemical protective glove

Permeation level: 1

Cotton flocking on the inside

Butyl chemical protective glove

Permeation level: 3

Gas-tight and resistant to exhaust gases produced by combustion processes

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.