Adhesive lubricant HHS® foodstuffs 08931076

0x - +	Գինը գրանցվելուց հետո	Ավելացնել զամբյուղ

Specification

Waterproof, synthetic adhesive lubricant with penetrating properties

Can be used in areas in which food is processed or stored

NSF H1-registered. The product may come into contact with foodstuffs for technical reasons.

Excellent penetrating properties

For lubrication in hard-to-reach places
Penetrates very tight spaces and tolerances

Good adhesive properties

Broad application range, e.g. on vertical lubrication points
Resistant to centrifugal forces on turning and rotating parts

Provides lasting protection against corrosion and non-ferrous metal corrosion

Waterproof

Resin-free and acid-free

Silicone-free and AOX-free

Notice

If used in areas in which food is processed or stored, only the minimum quantity technically necessary may be used. When using as an anti-corrosive film for food contact surfaces, completely remove all lubricant before re-starting the device.

The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Application

Suitable for universal lubrication at high pressure loads, e.g. for chains, racks, joints, levers, bearings, sliding points, cables, open drives, and hinges.

Instructions

Shake can well before use. Thoroughly clean the lubricating point and then apply where required.

Technical information

Chemical basis	Synthetic oil with a multifunction additive combination
Colour	Colourless
Smell/fragrance	Characteristic
Density	0.8 g/cmu00b3
Density conditions	at 20u00b0C
Min. temperature conditions	-25 u00b0C
Max. temperature conditions	180 u00b0C
Min. flashing point	200 u00b0C
Kinematic oil basis viscosity	1251 mmu00b2/s
Conditions for viscosity of oil basis	after evaporation of solvent at 40u00b0C
Silicone-free	Yes
Acid-free	Yes
Resin-free	Yes
AOX-free	Yes
Resistance against	Water
Contents	500 ml
Container	Aerosol can
Shelf life from production	24 Month

Suitable glove:

Nitrile chemical protective glove

Permeation level: 6

Cotton velour lining

Nitrile chemical protective glove, heavy-duty

Permeation level: 6

Long, heavy-duty design

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Measured breakthrough time	Permeation level
< 10 min	0
u2265 10 min	1
u2265 30 min	2
u2265 60 min	3
u2265 120 min	4
u2265 240 min	5
u2265 480 min	6

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.

Տեղեկություններ ապրանքի վերաբերյալ