First remove pressed in and loose parts. Ratio of 2 cm (repair filler): 1 cm (hardener). Both components are mixed intensivelyu2014within a minute where possibleu2014as the mixture sets within 4u20138 minutes. In small portions, the filler must be firmly pushed into the repair area in order to achieve optimum anchoring. Using the glass transparent film, which is first placed onto the area, the excess compound is scraped outwards using the plastic plane (art. no. 0890 305 30). When mixing, ensure that the compound does not become too hard.

The film can be removed after 5u201310 minutes; clean the spatula, mixing plate and the film with correction solvent before hardening. Further processing can take place when the surface is no longer tacky when under load. It takes approx. 20u201330 minutes for the compound to fully harden. Excess material can be scraped away with the plastic plane. To level the surface, carefully sand the area with sandpaper, which is located inside the plane. The colour of touch-up areas can be adjusted using the retouching paint box (art. no. 0890 305 1). The level of gloss can be adjusted again using clear varnish (art. no. 0893 188 2/188 3) and the damaged area is sealed.