Vapor sampling is the most common method used for identifying refrigerants using the T-LineMini ID™. It is a simple process requiring the operator to take these 4 steps:

1) Connect the Low Pressure Vapor Sampling Hose to the Low Side Vapor portof the system or cylinder.

2) Open the low side valve of the cylinder and press ‘TEST’.

3) When the test is complete, close the low side valve of the cylinder anddisconnect the hose from the cylinder.

4) Disconnect the hose from the T-Line Mini ID™ for storage.

WARNING: Be sure to turn off the vehicle and let it rest for 3 minutes.

1. Connect the power cable to the power port located on the bottom of the instrument.
2. Connect the power clips to the 12 VDC battery source. Be sure to observe thecorrect polarity.
3. The lights will sequence, press “NEXT” to begin the “WARM UP”.
4. After approximately 90 seconds, the “CALIBRATING” light will flash.
5. Fully squeeze the calibration bulb 5 times and press “NEXT”.
6. The “CALIBRATING’ light will illuminate for approximately 60 seconds.
7. When the Analyzing light begin to flash, connect hose to the vehicles low sideservice port and then press “NEXT”.
8. The Analyzing light will illuminate for approximately 45 seconds while the test is inprogress.
9. The “PASS”/”FAIL” light will then provide the test results (See The Test Results)
10. Disconnect the sample hose from the vehicle, press the “NEXT” button and squeezethe calibration bulb 5 times. Remove the power and the instrument may now bestowed.