For bonding metal, plastic and rubber parts with and to each other in a matter of seconds.

Patented special cap

• One-handed operation
• Precise dispensing
• Prevents you from gluing the tip

Bonds in seconds

• Can be processed immediately
• Fast repairs
• Simple construction without additional mounting materials
• Increased temperatures not normally required

Solvent-free

Notice

It is advisable to wear safety gloves and goggles.

The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

The parts to be adhered must be clean and free from grease.

Suitable glove:

Nitrile chemical protective glove

Permeation level: 2

Cotton velour lining

Nitrile chemical protective glove, heavy-duty

Permeation level: 3

Long, heavy-duty design

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.