Solvent-free, acrylic dispersion-based adhesive with high initial strength for bonding a wide range of indoor materials

• Can be painted/coated
• Resistant to weathering
• Resistant to ageing
• Silicone-free
• Compatible with Styrofoam
• Stable

Notice

This information is intended to advise you, to the best of our knowledge, based on our tests and experience. However, due to the large number of applications and the storage and handling conditions that lie outside the scope of our influence, we assume no liability for the application results in individual cases. This also applies to the use of the non-binding technical and commercial customer services provided by us. We always recommend that you conduct your own tests. We guarantee the consistent quality of our products. We reserve the right to make technical changes and further develop products.

The usage instructions are recommendations based on the tests we have conducted and based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

The wide spectrum of surfaces such as wood, Styrofoam, steel, aluminium, PVC, hard foams made from PVC and PU, gypsum plasterboard, mineral fibreboards, masonry, concrete and various plasters. For securing baseboards, panels, insulating and decorative boards, wall cladding, door sills, wood profiles, decorative profiles etc.

Instructions

The surface must be clean, load-bearing, dry and free from dust and grease. Apply to the surface to be adhered at a spacing of 20-40 cm, with horizontal or vertical serpentine lines. Then firmly press on the joint part. At least one of the two surfaces to be adhered must be absorbent.

Suitable glove:

Nitrile chemical protective glove

Permeation level: 6

Cotton velour lining

Nitrile chemical protective glove, heavy-duty

Permeation level: 6

Long, heavy-duty design

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.