pH-neutral car shampoo for active-cleaning brush washing of passenger cars and commercial vehicles

Based on active cleaning surfactants

• Dirt particles are completely encapsulated and can be rinsed away with water
• Good cleaning results

Combination of special ingredients enables brushes to slide better

• Protects vehicle surfaces
• Prevents brushes from getting dirty

No streaking when using preservers and drying aids

Can be used with these in machines with water recycling systems

Easily biodegradable in accordance with OECD*.

Does not compromise the effectiveness of light fluid separators

* OECD = Organisation for Economic Co-operation and Development

Notice

• Do not allow to dry!
• Store in a frost-free place!

The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

For cleaning vehicles in automatic car washes

Instructions

• Dispense undiluted in the brush washing system using the dispensing pump. When dispensing using an injector, dilute beforehand with 1 part active wash to 9 parts water.
• Application concentration: 0.02-0.2%
• Consumption per vehicle: approx. 12-14 ml

Suitable glove:

Nitrile chemical protective glove

Permeation level: 3

Cotton velour lining

Nitrile chemical protective glove, heavy-duty

Permeation level: 4

Long, heavy-duty design

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.