Preparation:

The substrate must be tested for compatibility with the adhesive.

The substrates must be solid, load-bearing, clean, dry and free from grease and dust. Remove any release agent that may be present. If necessary, prime with Bond and Seal HaftPlus metal (Art. No. 089010061) or Bond and Seal HaftPlus plastic/wood/stone Art. No. 089010062).

Some applications require a primer, e.g. heavy mechanical load or above-average load with water after hardening.

Installation:

Apply the EPDM sealing tape adhesive to the surface and wipe off with a toothed spatula. Depending on the film width, the adhesive width should be a minimum of 40 mm on the building and a minimum of 30 mm on the element, with a thickness of 1 mm in each case. Pay attention to the planning specifications if a full-surface bond is required. With film overlaps, maintain an overlap length of at least 10 cm.

Glue the EPDM tape to the surface and press on lightly using a press-on roller (Art. No. 0693011750) , while ensuring tension-free installation. After pressing on the film, the bonded should have a layer thickness of min. 1 mm and be completely filled with adhesive, without air inclusions. The tape can be adjusted up to 30 minutes after bonding. Use up open containers as quickly as possible. During application and curing, avoid contact with alcohol, hydrocarbons, cleaning agents and solvents.