Ներկի պաշտպանիչ թաղանթ 089410015

0x - +	Գինը գրանցվելուց հետո	Ավելացնել զամբյուղ

Specification

Protects against expensive paint damage caused by parking dents, scratches on door steps or loading edges from loading/unloading as well as protecting against rust caused by stone chips.

Paint protection film u2013 polyurethane-based

Resistant to scratches, stone chips and wear (prevents corrosion from forming)
High degree of transparency, i.e. not immediately visible after bonding
Good UV-resistance

Simple self-assembly and disassembly with overall thickness of 0.36 mm

Can be stretched without deforming, even around curves and corners
Non-slip and soundproof

Acrylate adhesive in conjunction with Wu00fcrth assembly fluid

Permanent hold (even in car wash facilities)
Guarantees removal of the paint protection film with no residues left behind
Resistant to heat, cold and petrol

Simple self-assembly:

Before application, thoroughly clean the paint surface to be adhered of grease and dust; remove any paint polish. Lay in a location that is protected from wind, dust and direct sunlight. Only glue Wu00fcrth paint protection film when wet. Do not apply to freshly painted surfaces!

Simple disassembly:

Starting from any corner, the Wu00fcrth paint protection film can be removed in a single piece without leaving any residue. It is advisable to warm the relevant corner slightly with a hair dryer so that it is easier to grip.

Notice

Please note that the paint protection film must only be used in conjunction with Wu00fcrth assembly fluid. Only when this liquid is used can optimum assembly, a permanent hold and residue-free removal be guaranteed.

Optimum bonding of the film with the surface is reached after approx. 48 hours. Until this point, do not attempt to adhere anything or expose the glued paint protection film to major stresses (such as car wash facilities, steam jets etc.).

The usage instructions are recommendations based on the tests we have conducted and based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Application

The paint protection film can be used on all paint areas (cars, trucks, buses, motorbikes etc.) particularly at risk, e.g. bumpers, bonnets, wheel trims, mudguards, door sills etc.

Instructions

1. Cut the Wu00fcrth paint protection film to the required size. Intended for license plate lights, key holes, fog lights etc. with corresponding cut-outs. First tape over the cut-out for license plate lighting etc., use a pen to mark the cut-out on the paint film, remove the paint protection film, and cut out the marked hole with scissors.

2. Remove the backing paper. Generously moisten the adhesive film side and the paint surface to be glued with Wu00fcrth assembly fluid (spray bottle). Position the paint protection film. The film can be stretched without deforming around curves and corners. Using a blade, spread the assembly fluid in overlapping lines, working from the inside outwards.

3. However, if there are still air or water bubbles, remove as much of the paint protection film as is necessary, spray again with assembly fluid and repeat the process. With any folds, lightly heat up with a hair dryer and smooth the film using a blade.

Technical information

Backing material	Polyurethane film
Adhesive base	Acrylate
Colour	Transparent
Material of the cover	Adhesive-repellent paper
Foil thickness	0.36 mm
Min./max. temperature resistance	-40 to 120 u00b0C
Max. temperature resistance	120 u00b0C
Width	15 cm
Length	10 m