Special cleaning foam with anti-static additive for the entire vehicle interior

Cleans nicotine, dirt and dust from all painted and plastic parts, glass surfaces and upholstery

Interior cleaning in one action

Anti-static additive offers temporary dust protection on the surface

Lasting cleanliness of the vehicle interior.

Does not run off vertical surfaces, i.e. the agent stays where it needs to act

Economical use due to minimised run-off

Intensive action reliably loosens dirt

Saves time, as repeated wiping is not required

Visible white foam

Saves time and materials as each spot is sprayed only once

Pleasant, fresh aroma in the interior at all times

No more unpleasant nicotine odour in the cockpit

Silicone free

Notice

Do not spray directly on sensitive surfaces. Spray the interior cleaner onto a clean cloth and wipe the surfaces to be cleaned. Do not use on hot surfaces or in direct sunlight.

For optimum foaming, shake the can well before use!

The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Instrument panel, vehicle ceiling, door trims, seat upholstery, seat backrests, sun visors, console.

Suitable glove:

Nitrile chemical protective glove

Permeation level: 5

Cotton velour lining

Nitrile chemical protective glove, heavy-duty

Permeation level: 5

Long, heavy-duty design

Butyl chemical protective glove

Permeation level: 6

Gas-tight and resistant to exhaust gases produced by combustion processes

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.