089216 | Wurth.am

0x - +	Please log in to see the price	Add to cart

Specification

For removing fresh polyurethane foam

Highly-effective

Dissolves all fresh foam soiling easily and quickly.

500 ml can is adapted to PU foam guns

It is particularly well suited for cleaning foam guns.
The 500 ml can contains an additional spray head for external cleaning of foam guns and other surfaces.

Notice

Can etch surfaces such as lacquer, paint and plastics. Can cause colour fading or dissolving in textiles. Hardened PU foam can only be removed with PURLOGIC foam cleaner, art. no. 0892 160 000, or mechanically.

The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Application

For cleaning fresh splashes of PU foam on surfaces such as wood, metals and clothing. Ideally suited to cleaning the gun adapter basket.

Instructions

First remove the black cap. Screw the PURlogic Clean can all the way into the gun support u2013 do not screw too far or tilt. Let the cleaner take affect inside the gun for approx. 1 to 2 minutes; then let the cleaner drain out into a suitable container (e.g. carton) through the opening in the gun tip until the cleaner runs clear. If necessary, repeat this process two or three times. Once the cleaning process is complete, remove the gun from the cleaner can. The gun can then be stored depressurised.

To clean the exterior of the foam guns or other surfaces, clip the red spray head onto the can.

Technical information

Chemical basis	Acetone
Colour	Transparent
Density	0.78 g/cmu00b3
Density conditions	at 20u00b0C
Silicone-free	Yes
Acid-free	Yes
Resin-free	Yes
AOX-free	Yes
Contents	150 ml
Weight of content	117 g
Container	Aerosol can
Shelf life from production	12 Month

Suitable glove:

Natural latex and neoprene chemical protective glove

Permeation level: 1

Cotton flocking on the inside

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Measured breakthrough time	Permeation level
< 10 min	0
u2265 10 min	1
u2265 30 min	2
u2265 60 min	3
u2265 120 min	4
u2265 240 min	5
u2265 480 min	6

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.

Product information