Lithium-complex lubricating grease, partly based on synthetic oil in a Lube-Shuttle® cartridge system

Broad range of applications

One lubricating grease for most lubricating points, hence simple stock keeping and optimised application reliability

Extremely high pressure absorption capacity

Good corrosion protection

Water-repellent

Silicone-free, acid-free and resin-free

Lube-Shuttle®- system cartridge

• Simple, safe and clean application when used with Lube-Shuttle® grease presses
• Refillable - therefore cost-effective
• Grease type identification and fill level monitoring

Notice

Suitable for use only in  Würth Lube-Shuttle® hand-lever grease gun.

Not suitable for lubricating points on which lubricating greases containing solid lubricants are specified, such as track rod joints. We recommend using multi-purpose grease II, art. no. 08938711, for this purpose.

The operating instructions of the major assembly and commercial vehicle manufacturers must be observed! For further information, refer to the technical data sheet. Store upright in a cool, dry place!

The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

For lubricating points subject to medium and heavy loads on commercial vehicles, such as wheel bearings (axle boxes), cardan shaft bearings, final drives, trailer couplings, liftgates, wheel hubs, cardan joints, axle legs, wheel suspension, lifting equipment, handbrake connecting rods, dump truck suspension, semi-trailers etc.

Instructions

Clean and degrease the parts to be lubricated. Then apply the grease in the required coating thickness.

Art.-no.: 098605

Hand-lever grease gun Lube-Shuttle u00ae

GRSEGUN-HNDLEVER-LUBESHUTTLE

The system for lubricating greases in 400-g system cartridge

Suitable glove:

Nitrile chemical protective glove

Permeation level: 6

Cotton velour lining

Nitrile chemical protective glove, heavy-duty

Permeation level: 6

Long, heavy-duty design

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.