High-quality rust remover with cracking effect and visual cold indicator

Cracking effect

By cooling the material surface down to -45°C, micro-fine cracks occur in the corrosion layer at the connection points. These "crack open" the rust, ensuring better penetration of the active agent

Visual cold indicator

When cooled to a minimum temperature of -5°C, the sprayed area turns blue. The processing temperature is achieved.

Optimum rust removal

• Rust is quickly penetrated and loosens seized up screws
• Heavily rusted screw connections are loosened without damaging them

Optimum corrosion protection due to addition of corrosion-protection additives

Long-term protection against further corrosion

Resin and acid-free

Silicone-free

Compatible with rubber and seals

The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

For non-destructive loosening of extremely rusty and oxidized screw connections on passenger cars, trucks, agricultural machines, construction machines, equipment and devices.

Instructions

Remove as much of the coarse soiling as possible. Shake can before use. Spray the jammed parts (bolts) from an extremely short distance until the sprayed area turns blue. With stubborn parts, repeat the process.

Suitable glove:

Nitrile chemical protective glove

Permeation level: 6

Cotton velour lining

Nitrile chemical protective glove, heavy-duty

Permeation level: 6

Long, heavy-duty design

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.