Glass fibre reinforcement filler for bridging cracks, holes and for repairing glass fibre reinforced plastics.

Balanced proportion of glass fibres

• Excellent application properties
• User-friendly

Excellent adhesion and stability

• Highly suitable for use on vertical surfaces
• Superb adhesion to iron, steel, aluminium, galvanized and hot-dip galvanized surfaces.
• Ideally suited as knifing filler after repairing GFRP parts with VAKU 80 repair resin.

Fast curing

• For fast, time-saving further processing.

Maximum permissible VOC content of VAKU 70: 250 g/l of product category 2(b). Max. VOC content in accordance with German Ordinance on Solvent-Based Paints and Lacquers (ChemVOC FarbV): 4 g/l.

Heat-resistant up to 80°C

Notice

Tip: Can be coated with VAKU 20, VAKU 30 and VAKU 40 filler without sanding in between coats.

To prevent possible complaints, always ensure the correct dosing ratio between the filler and hardener.

The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Auto/cargo:

In vehicle construction and vehicle repairs for levelling unevenness, cracks and holes. For repairing glass fibre reinforced plastics. Attachments on trucks and passenger cars.

Metal:

In machines and steel construction for compensating larger damaged areas. For repairing glass fibre reinforced plastics.

Instructions

The surface must be clean, dry and free from grease. Sand surfaces Wherever possible, only sand polyester material when dry due to its sensitivity to water. See separate information on wet sanding.

Filler VAKU 70 including:

1x

Art.-no.: 0892600004

Hardener for filler

HDNR-FILR-VAKU-TUBE-40G

Suitable glove:

Natural latex and neoprene chemical protective glove

Permeation level: 1

Cotton flocking on the inside

Butyl chemical protective glove

Permeation level: 3

Gas-tight and resistant to exhaust gases produced by combustion processes

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.