High-performance assembly paste spray for run-in lubrication

Protects against wear and guarantees emergency running properties

Solid lubricating film reduces friction, prevents running hot and hot seizing.

High resistance

Resistant to water, salt water, diluted acids and alkalines

• The 60% solids content is resistant to petrol, diesel fuel etc.

Temperature- and pressure-resistant

• Thermally stable from -35°C to +150°C, higher temperatures are possible for short periods of time if the air inlet is reduced
• Pressure-resistant up to yield point of all known metals

The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

• As run-in lubricant for new machines, guides, threaded spindles, splined shafts, heavily loaded toothed gearing, worm gears and manual gearboxes, gearwheels and toothed racks, as well as for chemical apparatus
• Plain bearings subjected to heavy thermal and surface loading, pressed seats of all kinds for pulling on and pressing in rolling bearings, pulleys, wheels, flanges and pins; fittings (slide valves, valves, taps)
• For deep-drawing, tapping, drilling and sawing
• For cutting, punching and bending tools

Instructions

Shake the product before use. Spray onto the surface to be treated and steam off the solvent.

Suitable glove:

Nitrile chemical protective glove

Permeation level: 6

Cotton velour lining

Nitrile chemical protective glove, heavy-duty

Permeation level: 6

Long, heavy-duty design

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.