Dry lubrication, does not attract dirt and dust

Eliminates squeaks, creaks and stiff movement

Offers lasting wear protection

Film thickness of 1µm

Can be used for even the smallest tolerances in precision engineering

Very high resistance

• Resistant to temperatures from –180°C to +260°C (briefly)
• Permanently resistant to water, acids and alkalis

Mineral-oil-free

Silicone-free

Notice

Smokers must wash their hands after use. Smoking contaminated tobacco products may cause health-related issues.

The usage instructions are recommendations based on the tests we have conducted and based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and carry out further development.

Suitable for dry lubrication of friction points. Can be used for metals, plastic, rubber etc. under low and medium loads.

Ideal for sliding roof and seat rails, door hinges and locks, sliding doors, window tilt mechanisms, window locks, furniture hinges, drawers, guide rails, ball bearings, electrical switches etc.

Also suitable as a release agent if applied economically.

Instructions

• Shake briefly before use. Spray a thin layer onto friction points or joints and allow to dry
• Drying time for a thin application: approx. 1 - 2mins.
• Drying time for a thicker application approx. 5 mins.

Suitable glove:

Nitrile chemical protective glove

Permeation level: 6

Cotton velour lining

Nitrile chemical protective glove, heavy-duty

Permeation level: 6

Long, heavy-duty design

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.