0892078550 | Wurth.am

0x - +	Please log in to see the price	Add to cart

Specification

Vapour-permeable underbody seal for use on wooden underbodies

Excellent adhesion to wood
Tested compatibility with commercially available wood impregnation compounds
Excellent anti-drone effect
No dripping off vertical surfaces
Highly resistant to ageing
Moisture exchange in wood is ensured by the breathable properties of the underbody seal.
Penetration of moisture and other environmental influences is prevented
Corrosion protection properties
Resistant to spray
Weather-resistant
Abrasion-resistant

Notice

Store the product in a cool, dry place. Recommended storage temperature +10u00b0C to +30u00b0C. Protect from direct sunlight. Product can be removed again after application with thinner. Once dried, the product can be removed again only by mechanical means. Turn the can upside down and spray until the valve is empty after use.

The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Application

Special underbody seal for application on wooden underbodies of caravans, mobile homes, trailers etc. Can also be used for chassis, wheel wells and side skirt trim panels of passenger cars, commercial vehicles and buses.

Instructions

Shake can well before use. The surface must be dry, clean and free from rust and grease. Optimum spraying distance: 30 cm. With thicker coats, allow intermediate coats to flash off.

Technical information

Chemical basis	Mix naphtha, solvent, propellant
Surface pre-treatment required	Surface must be clean, dry and free from rust and grease.
Contents	500 ml
Weight of content	406 g
Colour	Black
Min. proportion of solids	33 %
Conditions for thorough drying	at 20u00b0C, 65% relative humidity
Min. spraying distance	30 cm
Conditions for skin-formation time	20u00b0C, Ri 0 at 65% relative humidity, 100 u00b5 wet layer thickness
Min. skin-formation time	75 min
Drying time	135 min
Conditions for drying time	at 20u00b0C and 65% relative humidity
Density	0.79 kg/l
Density conditions	at 20u00b0C
Shelf life from production	24 Month
Max. temperature resistance	80 u00b0C
Min. temperature conditions	-25 u00b0C
Min. temperature resistance	-25 u00b0C
Recoatable/Can be painted over	No

Product information