Black, shear-resistant, high-pressure resistant special lubricant

Resistant to high pressures

• Reliable protection against wear even under high pressure demands
• Noise- and vibration-damping

Shear-resistant

Excellent lubrication including for fast rotating lubrication points

Addition of solid lubricants

Has good emergency running properties (the solid lubricant prevents extreme wear in critical phases of removing the lubricating film).

Contains corrosion protection additives

Penetrates moisture and protects against corrosion

O-ring compatible

Resistant to spray water and salt water, as well as to weak acids and bases

Silicone-, resin-, acid- and bitumen-free

Notice

Soiled lubrication points must be thoroughly cleaned and degreased with 1A cleaner, art. no. 0890 106 500, prior to application.

The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Particularly suitable for exposed lubrication points that are exposed to water or weathering. For use on covered or exposed crown gears on winches and crushing plants, gearwheels and ring mounts on cranes and diggers, toothed racks, chains, pinions, gearboxes etc. for indoor and outdoor use.

Instructions

Clean and degrease the workpiece. Shake can vigorously before use. Evenly spray lubricating point from a distance of approx. 20 cm. With running gearwheels, always point the continuous spray jet at the same area. Turn the can 180°C and spray for approx. 5 seconds after use.

Required accessory:

Art.-no.: 0890106500

1A assembly cleaner

ASMBYCLNR-1A-500ML

Highly active and safe assembly and parts cleaner

Suitable glove:

Nitrile chemical protective glove

Permeation level: 5

Cotton velour lining

Nitrile chemical protective glove, heavy-duty

Permeation level: 6

Long, heavy-duty design

Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.