EP long-life spray grease with a high protective factor against weathering and environmental influences
Low adhesion of dust and dirt
- Ideal for open lubrication outdoors
- Longer lubricating grease life
- Outstanding sealing behaviour
- Extends lubrication intervals
Resistant to salt water and spray water, weak acids and bases
- Outstanding corrosion protection
- Lubricant does not wash off
- Resistant to oxidation
High pressure load of lubricated parts
- EP (extreme pressure) additives for extremely high pressure resistance
- Outstanding noise and vibration damping
Minimises wear and substance loss of lubricating points
- Reduces friction temperature which extends the lubricating effect
- Low wear
Free from silicone, resin and acids
The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.
Suitable for exposed lubricating with heavy dirt and weather influences, e.g. gearwheels, bearings, wire cables, spring balancers, journal bearings and much more. HHS Lube is ideally suited for exposed outdoor lubricating thanks to its low adhesion of dust and dirt. The highly viscose spray grease with anti-wear and anti-corrosive properties is also ideal for lubricating door pins, hinges, sliding rails, chains, chain wheels, cable winches, spindles, gearwheels, toothed racks and much more.
Instructions
Shake can well before use. Thoroughly pre-clean the lubricating point with HHS CLEAN, art. no. 0893 106 10. Then spray onto the cleaned surface
Suitable glove:
Nitrile chemical protective glove
Permeation level: 6
Cotton velour lining
Nitrile chemical protective glove, heavy-duty
Permeation level: 6
Long, heavy-duty design
Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.
Measured breakthrough time
|
Permeation level
|
< 10 min
|
0
|
≥ 10 min
|
1
|
≥ 30 min
|
2
|
≥ 60 min
|
3
|
≥ 120 min
|
4
|
≥ 240 min
|
5
|
≥ 480 min
|
6
|
|
Important information:
The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.