• High-quality two-component reaction resin system that exhibits characteristics similar to those of metal due to its special formula
• The ideal mixing ratio of the components (A:B = 1:1, pressing out two strands of the same length from the tubes) makes incorrect mixing of the repair compound virtually impossible
• Specifically designed for smaller repair jobs where a quick turnaround is required
• Can be applied with a spatula and does not run, which also makes vertical application possible
• After hardening, Liquid Metal Fe1 can easily be processed in the same way as metal with lathing, milling, drilling, filing or thread cutting

The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Particularly suitable for filling moulds, and for sealing and covering leaking areas.

Example applications

• Abrasions on pump housings, impellers, propellers, rudders, heat exchangers, condensers, dust lines, slides, chutes, pins, broken threads
• Sealing leaks on coolers, tanks, water containers, water lines, oil lines, housings
• Cavities in grey cast iron during casting, grey cast iron during processing
• Running-in damage on shafts, hydraulic cylinders, engine blocks, bearing seating, crank houses
• Manufacturing of moulds, holders, models, guides, prototypes

Instructions

The metals must be cleaned and degreased bare. Mix components A and B homogeneously 1:1. Apply the mixture immediately with a spatula (short pot life). The hardened liquid metal can be easily machined by lathing, milling, drilling etc. Please note the enclosed application instructions.